ENGLISH
32
WET & DRY TANK INSTALLATION
Note: It is not suggested to use the scrubbing function for the rst-time use.
1. Open the tank’s rubber lid, ll the tank with water carefully so water does not come
out and close it again. Make sure the silicone clip is properly closed to avoid water from
spilling.
2. Install the tank in the robot following the indicated direction. Make sure the clip is
properly fastened.
3. Only for Wet & dry tank installation:
Attach the mop to the bottom part of the mop bracket with the Velcro.
4. Manually press the clips on both sides of the Wet & dry tank and push it into its correct
position until you hear a click indicating it is properly xed.
To Next Page
Loading...
