ENGLISH
38
2. Use the up and down direction buttons and the button to set the current time. Then,
use the left and right buttons to switch from hours to minutes and repeat the previous step.
3. Press the button again to save the settings.
2. Scheduling cleaning tasks
1. Hold down the button for 3 seconds. The rst 2 digits indicating
the hour will start blinking.
2. Use the up and down direction buttons and the button to set the schedule time. Then,
use the left and right buttons to switch from hours to minutes and repeat the previous
step.
3. Press the button again to save the settings.
4. To cancel the scheduled cleaning:
• Set the remote control’s clock to 00:00 am and save it.
• Switch the robot off for 1 minute and switch it on again.
Note: The robot will beep to indicate all settings have been saved.
Warning: When the remote control’s batteries are replaced, the clock and schedule times must
be set again.
To Next Page
Loading...
