cecotec Conga 8090 Ultra - Water Tank Installation and Use; First Cleaning; Initial Cleaning Cycle Procedure

30 | CONGA 8090 ULTRA
ENGELSK
Note
- Take the robot to the charging base if the battery is low. The robot might
not turn on if the battery is very low.
- The robot will automatically turn on when placed on the charging base.
- The robot cannot be turned o during charging.
Water tank installation
Note
It is not suggested to use the scrubbing function for the rst-time use.
- Open the tank’s blue silicone lid, ll the tank with water carefully so water
does not come out and close it again. Make sure the silicone clip is properly
closed to avoid water from pilling. Do not immerse the appliance. Fig. 9.
- Install the tank in the robot following the indicated direction. Make sure
the clip is properly fastened. Fig. 10.
- Manually press the tabs on both sides of the Wet & dry tank and push it
into its correct position. You will hear a click when it is properly xed. Fig. 11.
Recommendations
- Do not use the scrubbing function while the robot is unattended.
- Remove the mop bracket when the robot is charging or not in use.
- If there are carpets in the house, set Restricted Areas to avoid the robot
from passing over them.
- Add some drops of cleaning agent (not corrosive) if considered necessary.
- To remove the mop bracket, press the release button and pull from it
outwards.
Warnings
- Using cleaning agents in excess might block water outlets.
- In order to achieve perfect scrubbing, it is suggested to moisten the mop
before using it.
First cleaning
- Once the robot and the charging base are completely installed, follow
these steps before scheduling the rst cleaning cycle.
- First of all, the robot must be fully charged. It is suggested to allow the
robot to charge overnight. When it is fully charged, it may carry out the
rst cleaning cycle and save the rst map. To do so, activate Auto cleaning
mode and Eco power level. It is very important to follow these indications
for the robot to recognize each and every corner in the house and to create
a complete map.
- If the house where the robot is going to be used is too big and the robot
runs out of battery, do not worry. The robot returns to the charging base,