cecotec Conga 8090 Ultra - Specialized Brush Cleaning; Dust Tank and Filter Maintenance; Side Brush and Sensor Care

CONGA 8090 ULTRA | 39
ENGLESK
- Tab
- Main brush
- Compartment
Silicone brush.Fig. 23.
To clean the silicone brush, follow the instructions on the previous section to
remove it from the robot and wash it with water and soap. Dry it thoroughly
before assembling it back in order to ensure ecient operation.
Jalisco brush.Fig. 24.
To clean the Jalisco brush, follow the previous section’s steps to take it out
and clean it with water. Dry it thoroughly before assembling it back in order
to ensure ecient operation.
Dust tank.Fig. 25.
- Take the dust tank out.
- Open the dust tank cover and empty it.
- Use the cleaning brush to clean the inside of the dust tank.
- Install the dust tank back in the robot.
- Empty it again before installing it back in the robot.
High-eciency lter.Fig. 26.
Remove the high-eciency lter and shake it to remove all the dust.
Note
- Replace the high-eciency lter every 3 months depending on the
frequency and type of use.
- Clean the lter periodically with a brush to avoid blockage. Do not use
water or detergents.
Side brush.Fig. 27.
Remove and clean the side brushes regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.
Free-fall sensors. Fig. 28.
Clean the free-fall sensors with a soft cloth regularly.
Warning
Always transport the product turned o and in its original package.