CONGA GRASSHOPPER 500 CONNECTED
131
ENGLISH
E3 The blade disc is blocked
1. Disconnect the mower.
2. Turn it over and check if
anything is preventing the
blade disc from rotating
properly. If the disc or motor
is damaged, contact the
ocial Cecotec Technical
Support Service.
3. Remove any obstructions you
nd.
4. Turn the mower upside down
and place it in an area where
the grass height is lower or
adjust the cutting height to a
higher level.
6. Switch on the mower. Press
the button and then .
E4 Bumper blocked 1. Switch o the mower.
2. Move the mower to an
unobstructed area.
3. Try to unblock the upper
housing.
4. If the above step does not
solve the problem, remove
the cover, and check the
magnet on the back. If the
magnet is missing, contact
the ocial Cecotec Technical
Support Service to have it
replaced.
5. If magnets are in place, check
that the rubber between
the cover and the mower is
correctly installed.
6. Switch on the mower again.
To Next Page
Loading...