cecotec CONGA GRASSHOPPER 800 CONNECTED - Page 132

CONGA GRASSHOPPER 500 CONNECTED
132
ENGLISH
E5 The mower is not in contact
with the ground
1. Disconnect the mower.
2. Position the mower in an area
where there are no obstacles.
3. Switch on the mower. Press
Switch on the mower. Press
the button and then .
5. If the error code still appears
on the display, switch o the
mower.
6. Turn it over. Check if there
is anything preventing the
wheels from turning.
7. If there is, remove it. Next,
turn the mower over again
and switch it on. Press the
button and then .
E6 The mower is upside down
1. Turn it over.
1. Turn it over.
2. Press the button and
then .
3. If the error still appears,
contact the ocial Cecotec
Technical Support Service.
E7 The slope sensor is always
activated
1. Disconnect the mower.
2. Check that the slope of the
ground does not exceed 15°.
3. Place the mower on a at
surface.
4. Switch on the mower. Press
the button and then .
5. If the error still appears,
contact the ocial Cecotec
Technical Support Service.