34
ENGLISH
Fig. 3.
Press the dust tank release button located on the bottom part of the main body. The dust tank
will spring out.
Then, press the dust tank lock button of the dust tank assembly in the direction shown. The
dust tank will slide out from the device.
Assembling the dust tank
Fig. 4.
Slide the tab on the dust tank into the slot on the bottom part of the motor housing until it
clicks into place (lock button).
Fig. 5.
Fig. 6.
Press the dust tank in the shown direction until it clicks.
4. OPERATION
Charge
The unit must be charged on the charging base.
Before the first use, the device must be fully charged. The charge time is 4-4.5 hrs. approx.
During the first use, the device must be fully discharged in order to ensure proper operation
of the battery.
Light indicator
During charge
Blinking: Charging
Steady blue: Fully charged
During use
Steady blue: In use
Blinking: 2 minutes of battery left
Note: The device cannot be turned on during charge.
5. CLEANING AND MAINTENANCE
Disconnect the appliance from the power supply and allow it to cool down before cleaning.
If the device is going to be stored for a long time, charge and discharge it.
Charge and discharge it every 3 times at the least.
05561_Conga Rockstar Micro 12000_Manual_YV_01200817.indd 3405561_Conga Rockstar Micro 12000_Manual_YV_01200817.indd 34 17/8/20 15:0817/8/20 15:08
To Next Page
Loading...
