Velvet and other textures that rapidly become shiny should be ironed in one direction with light
pressure applied. Always keeps the iron moving at every moment.
Pure wool fabrics (100 % wool) may be ironed with the steam iron. Preferably set the
temperature knob to the third position and use a dry cloth as a mat.
Never iron over zips or rivets in the cloth. This will damage the soleplate.
Warning: When ironing woolen fabrics, shining of the fabric may occur. In this case, it is
suggested to turn the article inside out and iron the reverse side.
Setting Temperature Fabric
1 70 ºC-120 ºC Acetate, elastane, polyamide,
polypropylene
2 100 ºC-160 ºC Cupro, polyester, silk
3 140 ºC-210 ºC Triacetate, viscose, wool
Maximum 170 ºC-225 ºC Cotton, flax
4. CLEANING AND MAINTENANCE
Turn off, unplug the appliance from the power supply, empty the watertank (do it after each
use) and allow it to cool down completely.
Wipe deposits on
the soleplate with a damp cloth or a non-abrasive (liquid) cleaner. Warning:
Do not use abrasive scouring pads, powders or cleaners to clean the product. Clean the upper
part of the device with a soft damp cloth. Wipe water drops on the unit base and the
heatproof stand with a dry cloth.
If there is any fabric adhered to the soleplate, use a damp cloth with vinegar to wipe off the
soleplate.
To remove the mineral deposits gathered in the inner steam generator, follow these steps:
Make sure the steam station has completely cooled down before cleaning.
Fill the tank with clean water. Tap water may be used as long as it does not have a high content
of limescale. If it does, use 50 % tap water and 50 % low-mineral water.
Press and hold the power button while you connect the plug to a power outlet. It is very
important that you perform these two operations simultaneously. The device will beep twice.
Then press and hold the steam trigger until you hear a beep.
Press the power button again until it beeps twice. It is important that you do this as quickly as
possible. If the device does not beep twice, repeat the entire process from step 1.
Press and hold the steam trigger until the ON indicator light comes on steadily and all 3 steam
rate indicator flash.
05537_Fast&Furious 8060 Ultra_Manual_YV_01200601.indd 4005537_Fast&Furious 8060 Ultra_Manual_YV_01200601.indd 40 2/6/20 16:422/6/20 16:42
FAST&FURIOUS 8060 ULTRA
31
To Next Page
Loading...
