What to do if water leaks from the soleplate of my Cecotec Iron?
If water leaks from the soleplate of your Cecotec Iron, it could be due to two reasons. First, the iron might not be hot enough; wait until the red light indicator turns on. Second, the water level might be over the maximum mark; in this case, empty the excess water.
Why is the steam burst not working on my Cecotec Iron?
If the steam burst or vertical steam functions on your Cecotec Iron aren't working correctly, it might be because the steam-burst function has been used too often in a short period, or the iron is not hot enough. To resolve this, continue ironing in a horizontal position and wait a few minutes before using the vertical steam-burst function again.
What to do if the spray is not working on my cecotec 3D ForceAnodized 850 i-Pump?
If the spray function on your Cecotec Iron isn't working properly, it could be due to not enough pressure or air inside. Try pressing the spray nozzle manually and press the spray button several times in a row.
Why is my Cecotec Iron producing little steam?
If your Cecotec Iron is producing little steam, it could be due to blocked steam holes or too little water in the water tank. Clean the holes with distilled water and ensure there is enough water in the tank.
To Next Page
General