EasyManua.ls Logo

cecotec FORCECLIMA 7400 SOUNDLESS TOUCH - Operation; Device Power and Mode Selection; Sleep Mode and Temperature;Time Adjustment; Fan Speed Control

cecotec FORCECLIMA 7400 SOUNDLESS TOUCH
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FORCECLIMA 7400 SOUNDLESS TOUCHFORCECLIMA 7400 SOUNDLESS TOUCH
62
ENGLISH ENGLISH
Storage
- Store the device in well ventilated areas.
- Unscrew the drain cap, unplug the water plug, and discharge the water in the water tank
into other water containers or directly tilt the body to discharge the water into other
containers.
- Turn on the appliance, adjust it to low-wind ventilation mode, and maintain this state until
the drainage pipe becomes dry. This way, you will keep the inside of the body in a dry state
and prevent it from mildewing.
-               
wrapping post. Install the water plug and the drain cap.
- Remove the exhaust pipe and keep it properly.
- Cover the air conditioning with a plastic bag. Put the air conditioning in a dry place, keep it
out of the reach of children, and take dust control measures.
- Remove batteries of the remote control and keep them properly.
- Ensure that the body is placed in a dry place and keep all machine components properly.
Maintenance
Any person who is involved with working on or breaking into a refrigerant circuit should hold a

their competence to handle refrigerants safely in accordance with an industry recognised

6. TROUBLESHOOTING
Problems Possible causes Possible solutions
The air
conditioning
does not
work.
There is no electricity. Turn it on after connecting it to a socket
with electricity.
The full-tank indicator will

Discharge the water inside.
The room temperature is
too low or too high.
It is recommended using the appliance in at

In cooling mode, the room
temperature is lower than

heating mode, the room
temperature is higher than
the set temperature.
Change the set temperature.

the room temperature is
very low.
The appliance is in a room with a
temperature below 17°C.
Condensate water ooding protection function
When the water level exceeds the maximum level allowed by the safety buoy, the appliance


in the drainage instructions section). Once the water has been drained, the device will restart.
Automatic defrost
This air conditioner has an automatic defrost function.
Compressor protection function
            

5. CLEANING AND MAINTENANCE
- 
-             
product’s outside and prevent the accumulation of dust and dirt.
- If the product is not going to be used for a long time, store it in a safe and well-ventilated
place.
- Do not use detergent, scouring pads, chemically-treated cloths, petrol, benzene, alcohol,
thinner, or other solvents, as these can scratch and damage the tank and cause water
leakage.
- 
Cleaning the lter. Fig. 12
- 

- 
- 

- 
dry it in the shade after rinsing clean. Make sure it is completely dry before reattaching it.
Replacing batteries
The remote control is powered by two AAA batteries. If the remote control does not respond,
replace the batteries as follows:
1. Put the remote control face down and slide the tab outwards.
2. Remove the batteries.
3. Insert the batteries paying attention to polarity.

Table of Contents

Related product manuals