cecotec FORCECLIMA 7400 SOUNDLESS TOUCH - Appliance Protection Features; Cleaning and Maintenance; Filter Cleaning; Battery Replacement

FORCECLIMA 7400 SOUNDLESS TOUCHFORCECLIMA 7400 SOUNDLESS TOUCH
6766
ENGLISH ENGLISH
3. Repair of intrinsically safe components
- Do not apply any permanent inductive or capacitive load to the circuit without ensuring

- Intrinsically safe components are the only type of components that can be worked on
        
features.
- 
the refrigerant in the atmosphere from a leak.
4. Wiring
Verify that the wiring is not subject to wear, corrosion, excessive pressure, vibration, sharp


5. Detection of ammable refrigerants
Under no circumstances should potential ignition sources be used in the search for or detection

6. Leak-detection methods
- The following leak-detection methods are considered acceptable for systems containing

-            

be calibrated in a refrigerant-free area). Ensure that the detector is not a potential ignition



- 
containing chlorine must be avoided, as chlorine can react with the refrigerant and corrode
copper pipes.
- 
- 

the leak. Oxygen-free nitrogen must then be purged through the system both before and
during the brazing process.
7. Removal and evacuation
When intervening in the cooling circuit for repairs or any other purpose, conventional
procedures must be followed. However, it is important that best practices are followed, as

1. Remove the refrigerant.
- The charge size is in accordance with the size of the room within which the refrigerant
containing parts are installed.
- Ventilation machinery and outlets are properly operated and unobstructed.
- If an indirect cooling circuit is used, the secondary circuit must be checked for the presence
of refrigerant.
- 
should be corrected.
- The components or refrigerant piping are installed in a location where they are not
susceptible to exposure to any substance that may corrode the refrigerant containing
components, unless the components are constructed of materials that are inherently

1.9. Verication of electrical devices
Repair and maintenance of electrical components should include initial safety checks and
component-inspection procedures. If there is a fault that may compromise safety, then no
power supply should be connected to the circuit until the fault is satisfactorily dealt with. If
the fault cannot be corrected immediately, but continued operation is necessary, a suitable

as to inform all parties.
During initial safety checks, make sure
- 
- that no live wiring or electrical components are exposed while loading, recovering, or

- that there is continuity in the earth connection.
2. Repair of sealed components
- During the repair of sealed components, all power supplies should be disconnected from


operating form of leak detection should be placed at the most critical point to warn of a
potentially hazardous situation.
- Particular attention must be paid to the following to ensure that, when working on electrical

damage to cords, an excessive number of connections, terminals not conforming to the

- Ensure that the instrumentation is securely mounted.
- Ensure that seals or sealing materials have not degraded until no longer being useful to


NOTE:             
