cecotec FORCECLIMA 9050 - Air Filter Cleaning Procedures; Condensate Tank Emptying for Storage; Storage Cleaning Recommendations

ENGLISH
34 FORCECLIMA 9050
b) Cleaning the air lter
• Clean the air lters regularly every 2 weeks to ensure that the air conditioner remains efcient.
• First pull the upper air lter on the back out to the side. Then remove the lower air lter.
• Clean the air lters with a vacuum cleaner. If the lters are very dirty, wash them with
warm water (approx. 40 °C) and a mild detergent. Allow them to dry before installing
them again.
• Then re-install the air lters correctly.
MAINTENANCE
Switch off the appliance before all maintenance and remove the mains cable (11) with plug
from the mains socket.
a) Emptying the condensation tank
• Empty the condensation tank if the warning alarms (warning sound and ashing of the
backlight) indicate this is necessary or if you are planning not to use the product for a long
period of time.
• Unplug the mains plug from the mains socket.
• Remove the cover from the drainage hole.
• Remove the rubber cap from the drainage hole. The
water ows out immediately. Allow all the water to ow
out. If necessary, use a drain hose or place a container
under the drainage hole. Neither of these are included
with this product.
• Drain the water into a suitable container, outdoors or
into another suitable drain.
• Only allow condensation to run directly onto the oor if there is a good oor drain and the
oor is water resistant (avoid wooden oors).
b) Thorough cleaning before storage (at the end of the season)
• Remove the cover. Remove the rubber cap from the drainage hole. The water ows out
immediately. Allow all the water to ow out. If necessary, tilt the appliance slightly to one
side to allow all the water to come out.
• Refer to the maintenance section, paragraph a) Emptying the condensation tank.
• Run the appliance at low fan speed half a day after it has been fully emptied until it has
fully dried. This prevents the formation of mould in the interior of the appliance during
storage.
• Then switch the appliance off with the POWER button (8) and unplug the mains plug from
the mains socket.
• Wind the mains cable carefully, fasten it with a suitable tie (wire, string) and put the plug