ENGLISH
36 FORCECLIMA 9050
The cooling
effect is not
good.
There is direct sunlight. Avoid direct sunlight.
Doors or windows are open; there
are a lot of people; or in cooling
mode, there are other sources of
heat.
Close doors and windows, and add new air
conditioning.
The lter screen is dirty.
Clean or replace the lter screen.
The air inlet or outlet is blocked. Clear obstructions.
Big Noise.
The air conditioning is not placed on
a at surface.
Put the air conditioning on a at and hard
place (to reduce noise).
Compressor
does not work.
Overheat protection is activated. Wait for 3 minutes until the temperature is
lowered, and then restart the machine.
The remote
control does
not work.
The distance between the
machine and the remote control
is too far.
Let the remote control get close to the air
conditioning, and make sure that the remote
control directly faces to the direction of the
remote control receiver.
The remote control is not aligned
with the direction of the remote
control receiver.
Batteries are dead. Replace batteries.
Displays ‘E2’.
The pipe temperature sensor does
not operate properly.
Check the pipe temperature sensor and
related circuitry.
Displays ‘E1’.
The room temperature sensor does
not operate properly.
Check the room temperature sensor and
related circuitry.
NOTE: If problems not listed in the table occur or recommended solutions do not work, please
contact the Technical Support Service of Cecotec.
8. TECHNICAL SPECIFICATIONS
Model: ForceClima 9050
Product reference: 05261
Rated input power: 1010 W
Voltage and frequency: 220-240 V ~ 50 Hz
Cooling capacity: 9000 BTU/h | 2270 Fri/h | 2.64 kW
Refrigerant: R290/350g
Operating pressure | Suction: 0.6 MPa | Discharge: 1.8 MPa
Maximum pressure: 3.0 MPa
Air ow: 350 m
3
/h
Made in China | Designed in Spain
To Next Page
Loading...
