14
HYDROBOOST 2400 ADVANCECLEAN
• This device is not designed to pump hot water. Do not
connect the appliance to a hot-water supply, as this will
signicantly reduce the shelf life of the pump.
• Make sure the water inlet pressure is between 0.01 MPa and
0.4 MPa and that the inlet hose is at least 5 metres long.
• If the device is to be connected to a drinking-water supply,
install a disconnector on the water pipe to prevent dirty
water from backing up and entering the drinking-water
system. The disconnector must comply with EN 60335-2-
79 ANNEX A.
• This device must not be controlled by external switching
elements such as timers or connected to electrical circuits
that are continuously switched on and o.
• Release the trigger when switching from high to low
pressure.
• Keep the high-pressure hose away from sharp objects.
The burst of a high-pressure hose could cause injury.
Inspect the high-pressure hose regularly and replace it if
necessary. Do not try to x a damaged high-pressure hose.
• Keep all connections dry and o the ground to avoid risk of
electric shock. Do not touch the plug with wet hands.
• Do not use a pressure higher than the one permitted by
the parts of the pressurisation system (high-pressure
hose, connections, etc.). Make sure every component and
accessory is rated to withstand the maximum operating
pressure of the unit.
Repairing double-insulated devices
• A double-insulated device is equipped with two insulation
systems instead of an earth connection. No earth-
connection means are provided for double-insulated
devices, nor should they be added to the product. The
08139_HydroBoost 2400 AdvanceClean.indd 1408139_HydroBoost 2400 AdvanceClean.indd 14 18/11/22 9:5718/11/22 9:57
To Next Page
Loading...
