cecotec MICROONDAS PROCLEAN 6010 - 5. Cleaning and Maintenance; 6. Technical Specifications; 7. Disposal of Old Electrical Appliances

PROCLEAN 6010
51
ENGLISH
Watch cooking time: Cook for the shortest amount of time at rst, and add more minutes in
case it is necessary. Over-cooking may result in smoke and burns.
Cover food while cooking: Covering the food you are going to cook avoids spattering and allows
for a more even cooking.
Flip or stir food once during the cooking process.
Respect pre-heating time. Pre-heating time specied on the food’s label must not be exceeded.
5. CLEANING AND MAINTENANCE
The device, as well as food rests, must be cleaned and removed regularly.
Disconnect the power cord from the wall socket before cleaning. Do not immerse the product
in water or any other uid during cleaning.
Failure to maintain the product in clean conditions could lead to surface deterioration and
could adversely aect the product’s shelf life, resulting in possible hazard.
Never use strong detergents, abrasive powder or metal brush to clean any part of the product.
Do not remove the wave guide.
When the microwave has been used for a long time, some strong odours may arise from inside.
To eliminate these odours, follow one of the below methods:
Place several lemon slices in a cup and heat them at high power for 2 or 3 minutes.
Place a cup of red tea inside the microwaves and heat it at high power for 2 or 3 minutes.
Place orange peels inside the microwaves and heat it at high power for 1 minute.
Use a dampened soft cloth to clean enclosures, door, interior walls and the door frame.
6. TECHNICAL SPECIFICATIONS
Model: ProClean 6010
Product reference: 01536
Microwave power: 800 W
Voltage and frequency: 230 V, 50 Hz
Capacity: 23L
Made in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), species that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimise the recovery
and recycling of the materials they contain and reduce the impact on