cecotec Power Espresso 20 Professionale - Before First Use Guide

ENGLISH
15
POWER ESPRESSO 20 PROFESSIONALE
3. BEFORE USE
ADVERTENCIA: clean the product before the first use in order to remove production residues.
• Pour water into the water tank, do not exceed the “MAX” mark, and place the water tank
in its correct position.
Note: the appliance is provided with a detachable tank for easy cleaning. Fill the water tank
first and then place it in the appliance.
• Place the stainless-steel mesh in the funnel (without coee).
• Place a cup on the cup support. Make sure the steam knob is turned completely
anticlockwise.
• Connect the appliance to a power supply and press . The red indicator will light up
indicating the machine is preheating.
• Press for the pump to start pumping water. To stop it, press again. The preheating
process will be completed when the red and green indicator light turn steady.
• Press for the machine to dispense water.
• Once the machine has finished dispensing water, pour all remaining water away and
clean all the containers thoroughly. Now, the machine is ready to be used.
Warning: when activating the pump for the first time, the appliance may produce some noise
which will disappear after 20 seconds. This is because the machine is releasing air and is
completely normal, it does not aect to the product’s operating.
4. OPERATION
Preheating
It is suggested to preheat the appliance, including the funnel, filter and cup, so the coee flavour
is not aected by the fact of some of the pieces being cold.
1. Remove the detachable tank and open the tank cover to fill it with the desired amount of
water, do not exceed the “MAX” mark in the tank. Place the tank into the appliance properly.
2. Introduce the stainless-steel mesh filter into the funnel, pull the press bar backward, make
sure the funnel’s tube is aligned with the groove in the appliance, then insert the funnel into
the appliance and release the press bar.
3. Fix it firmly in the coee machine by turning it anticlockwise to the “lock” position.
4. Place an espresso cup on the cup support.
5. Connect the machine to the power supply and make sure the steam knob is turned
completely clockwise.
6. Press . The red light indicator will light up, indicating the machine is preheating. Press
again for the pump to start pumping water, and stop it by pressing the same button again.
This process will pump water from the tank to the boiler.
01556_Power Espresso 20 Professionale_Manual_DS.indd 15 20/12/18 9:27