cecotec PowerTwist Battery - Operation

POWERTWIST BATTERY 23
ENGLISH
- Please note that neither the mixer nor its charging base is waterproof.
- It is recommended to let the appliance rest for 1 minute for every 3 minutes of operation. If
you use it three times (stopping for 1 minute between each use), you will have to let it rest
for half an hour before using it again.
- Use a 5V-2A adapter to charge the appliance at optimum speed. The full charge cycle will
take 4 hours.
1. Before using the mixer, clean the beaters and make sure that it is fully charged.
2. Place the body on its charging base. Turn it until you hear a click. Fig. 2
NOTE: you will also hear a click when inserting the accessories.
WARNING: do not insert any metal knives, spoons or forks into the bowl when using the mixer.
4. OPERATION
NOTE: make sure the mixer is o before inserting or removing the beaters.
Operation
1. It is recommended to charge it fully before the rst use. Fig. 3
2. Insert the stainless steel beaters into the holes. Fig. 4
3. Move the knob to switch on the appliance. Fig. 5
4. Turn the knob to set the speed. Fig. 6.
5. When the appliance is on, you can set the knob to the 0 position to pause it. Fig. 7
6. Switch o the mixer before removing the beaters. Fig. 8
NOTE: turn the knob clockwise to increase the speed or counterclockwise to decrease it.
WARNING: before removing the accessories, make sure the mixer is switched o.
Accessories assembly
1. Make sure the hand mixer is disconnected from the mains.
2. There are two dierent beaters, one of type A and one of type B. Fig. 9
3. Insert the stainless-steel beater without collar (A) into the left opening (C) and the
stainless-steel beater with collar (B) into the right opening (D). Fig. 10
4. Align and push to t. Both stainless steel beaters will t.
5. Make sure the accessory is properly tted into place and securely xed.