cecotec PowerTwist Battery - Cleaning and Maintenance

POWERTWIST BATTERY24
ENGLISH
Charging the battery
1. Use the 5V-2A adapter and connect the USB charging cable. Place the mixer body on the
charging base. Fig. 11
2. Plug the charger (5V-2A) into a grounded outlet. Fig. 12
3. The battery status indicator light will ash when the mixer is charging. The battery will
be fully charged in 3-5 hours and the indicator light will turn green and remain lit. Fig. 13
4. If the overload protection system is activated, the mixer will switch o automatically. If
this happens, put the mixer on its charging base and restart it in order to use it again. Fig. 14
Charging status
A. Green indicator light: if the light is green, the battery is fully charged.
B. Red indicator light: if the light is red, the battery is low.
C. Flashing: if the indicator light is ashing, it means the battery is charging.
Reminder
1. When the battery level drops below 20%, the battery indicator light on the speed knob will
change from green to red to remind you to charge the mixer.
2. This hand mixer is not suitable for blending thick ingredients. If the food you are blending
is too sticky, the overload protection system will be activated and the mixer will switch o
automatically. If this happens, put the mixer on its charging base and restart it in order to
use it again.
5. CLEANING AND MAINTENANCE
1. Unplug the USB charging cable, remove the detachable accessories and wait for the mixer
body to cool down. Fig. 15
2. Wipe the outside of the mixer with a damp cloth and then use a dry cloth to dry it.
3. The accessories can be washed with water. Wash and dry them thoroughly before use.
Fig. 16
NOTE: metal or nylon brushes, detergents, thinners, and similar cleaning agents will damage
the surface of the mixer.
WARNING:
- The mixer body is not waterproof, so do not immerse it in water or any other liquid for
cleaning.
- Do not rinse the mixer with water at a temperature above 60 °C, as this may cause it to
become deformed.