28
READY WARM 5200 BOX CERAMIC
4. PRODUCT ASSEMBLY
The product must be installed on a wall before operating. Do not use it unless it is properly
installed.
• Drill 2 holes in the wall, 1.8 m above the ground, where the product is going to be installed.
The hole diameter must match the screw diameter.
• Once the holes have been drilled, insert the plastic stoppers and fix them leaving them at
3-5 mm from the wall.
• Place the appliance so that the plastic screws are introduced in the bottom part of the
appliance, against the wall.
5. OPERATION
• The display will light up when the appliance is turned on.
• The product can be controled from the control panel.
CONTROL PANEL
1. Power button
2. Modes
3. Timer
4. Max. mode
5. Eco mode
6. Week scheduling
7. Temperature adjustment
8. Timer
9. Window mode
To Next Page
Loading...
