cecotec TROTON - 3. Before Use

TROTÓN / TROTÓN FAT / TROTÓN BOING FAT 61
ENGLISH
Fig. 24
1. Speed up
2. Slow down
3. Power button
4. Bell
5. Accelerator
Note:
The graphics in this manual are schematic representations and may not exactly match the
device.
3. BEFORE USE
- This device includes a packaging designed to protect it during transport. Take the device
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the ocial Cecotec Technical
Support Service.
Box content Fig. 25
1. Electric footbike
2. Allen key
3. Adjustable pliers or wrench
4. Charger
5. Instruction manual
4. ASSEMBLY
Footbike assembly
1. Install the handlebar on the mast.
2. Use the hex spanner included in the tool kit to tighten the screws.
3. Front wheel mounting: place the wheel on the ground in an upright position and support
the fork of the footbike on the axle of the wheel using the front post guides provided for
this purpose. Make sure the wheel is centred and the brake system is aligned. First t the
washer and then tighten the nuts with the double ended open spanner on both sides of