cecotec TROTON - 7. Troubleshooting; Error Codes

TROTÓN / TROTÓN FAT / TROTÓN BOING FAT64
ENGLISH
- Charge the battery after each use and before storing the footbike to extend its life span.
- Do not expose the battery to temperatures above 45 ºC or below -10 ºC.
- Disconnect the charger after charging is complete.
- Removing the battery is complicated and may alter the operation of the footbike: you
can contact an authorised repair entity if the warranty is still valid. If the warranty has
expired, you can contact a specialist workshop of your choice. You can also contact the
Cecotec Customer Service Department.
- For proper removal of the battery for subsequent recycling, you must:
5. Remove the screws from the foot support area.
6. Removing the protective cover of the battery.
7. Disconnect the battery connector to the controller.
8. Removing the battery.
7. TROUBLESHOOTING
Error codes
- When an error occurs, the speedometer shall display the error code.
- The table below shows all error codes:
Component Error code Explanation
Controls
E 06 Battery fault
E 07 Motor failure
E 08 Accelerator failure
E 09 Controller failure
E 10 Communication reception failure
E 11 Communication failed to be sent
E 12 Communication failure with BMS
8. TECHNICAL SPECIFICATIONS
Product reference: 07112
(1)
/ 07113
(2)
/ 07114
(3)
Product: Trotón Footbike
(1)
/ Trotón Fat Footbike
(2)
/ Trotón Boing Fat
Footbike
(3)