Cedar Summit F25630 - Page 101

R5"
Step 27: Swing Beam Assembly
Hardware
A:Attach6HeavyDutySwingHangersto(270)EngineeredSWBeamusing2(G13)5/16x6-1/8”HexBolt
(with2atwashers,plasticformedwasherandlocknut)perswinghanger,asshowning.27.1.
B:Attach1QuickCliptoeachHeavyDutySwingHanger.(g.27.2)
12 x 5/16 x 6-1/8” Hex Bolt
(5/16” at washer x 2, 5/16” lock nut
& plastic formed washer)
4 x 5/16 x 3” Wafer Bolt
(5/16” at washer, 5/16” t-nut)
Other Parts
6 x Heavy Duty Swing Hangers
6 x Quick Clips
WB7
G13
Wood Parts
1 x Engineered SW Beam FSC 3 x 5-1/4 x 110”
270
C:Install4(WB7)5/16x3”WaferBolts(withatwasherandt-nut)in(270)EngineeredSWBeam,asshownin
g.27.3and27.4.AWaferBoltdoesnotgetinstalledontheSwingSideofthebeam.
IMPORTANT! MAKE SURE ALL 4 BOLTS ARE ATTACHED. THEY WILL MINIMIZE CHECKING OF WOOD.
R5"
Fig. 27.2
270
5/16”Flat
Washer
Fig. 27.1
Fig. 27.3
Fig. 27.4
G13
Plastic
Formed
Washer
5/16”Flat
Washer
5/16”
LockNut
HeavyDutySwingHanger
270
5/16”Flat
Washer
5/16”T-nut
WB7
Does not get
Wafer Bolt
Swing Side
Fort Side
9-3/4”
Notice this bolt is installed on the
opposite side of the other 3 bolts.
QuickClip
 101  support@cedarsummitplay.com