Cedar 801 - Attaching Panel Hangers; Hanging Panels onto Rails

5
 Attach the Left Panel Hangers (O) onto the left Wall Panel (1) and left Tower
panel (2) by using Flathead Phillips Screws (F), put the Left Panel Hanger (O) at
the ½ circle Indent at the top of the Panel, locate the Two pre-drilled Holes just
below the Indent. The bottom screw Holes of the Left Panel Hanger (O) should
match the pre-drilled ones.
 Repeat the steps to attach the two Right Panel Hangers (P) onto the right Tower
Panel (2) and the right Wall Panel (1).
 Add Panel Bracket (M) onto the bottom of the Wall Panels and Tower Panels (1 &
2) using Flathead Phillips Screws (F).
 Hang left Wall Panel (1) onto Wall Rail (G).
 Hang left Tower Panel (2) onto Wall Rail (G) at marked X location.
 Hang right Tower Panel (2) onto Wall Rail (G) at marked X location.
 Hang right Wall Panel (1) onto right end of Wall Rail (H).
Hint:
- You can level the Wall and Tower Panels(1 & 2) using the vertical and depth adjustment
screws on the Panel Hangers (O & P).