Please charge the CEECOACH and the
Jabra Steel headset. If the battery is too
low, pairing might not be possible.
1
Turn on your CEECOACH device first.
Then press the talk button (o) until
the LED starts flashing.
2
Set CEECOACH into pairing-mode by
pressing the plus button (+) and the
minus button (-) simultaneously until
the LED flashes yellow.
3
Turn on the Jabra Steel.
Press the On/Off button to do so.
4
Set Jabra Steel into pairing-mode by pres-
sing the answer/end button for 3 seconds
until the Bluetooth indicator flashes blue.
5
The pairing between CEECOACH and the
headset is finished in a few seconds.
You can see that the pairing has been
successful when CEECOACH flashes again
in the initial color.
USB-charging port
(Charging)
Plus button (+)
Talk button (o)
LED light ring
(flashes yellow in
pairing-mode)
Minus button (-)
Front view
Back view
On/Off button
Bluetooth
®
indicator
(flashes blue in pairing-mode)
Answer/end button
TIP:
In the delivery content of the Jabra Steel a windsock
is included. We highly recommend to use this for
reduction of ambient sounds.
jabra steel
USB-
charging port
Page 5
Pairing CEECOACH 2 with jabra steel
To Next Page
Loading...