Need help?Do you have a question about the ceepo Mamba and is the answer not in the manual?
Cable entry (1) is on the left side top tube. Thread casing into the hole until exit hole (2), then guide to rear brake caliper.
Route cable casing from top down tube entry (1) to bottom exit (2), then to front derailleur exit (3).
Route cable casing from top down tube entry (1) to bottom exit (2), then to rear derailleur exit (4).
Place wedge type clamp inside frame pocket, ensuring access to Allen key bolt head for tightening.
Place Mini-clamp on seat post prior to installation; it remains on seat post when removing it for travel.
To Next Page
General