Celestron CPC 9.25 - Page 6

6
However, if the hand controller
display reads “Press ENTER to
Turn GPS o” you need to do
as instructed and press ENTER.
The GPS is now turned OFF.
Now press the UNDO buon
to exit this menu area. Press
the UNDO buon a couple of
mes to get back to the CPC
READY screen
Scroll through the menu
system to set the current
date, me and me zone.
CPC READY
UTILITIES
SCOPE SETUP
SCOPE SETUP
SETUP TIME-SITE
TIME hh:mm:ss
xx:xx:xx
SELECT ONE
STANDARD TIME
SELECT TIME ZONE
ZONE 10
DATE mm/dd/yy
xx:xx:xx
From the CPS READY screen,
press the MENU buon. Use
the Up 6/Down 9 buons to
scroll through the opons unl
SCOPE SETUP is displayed.
Press ENTER to enter this
menu area.
When “Setup Time-Site” is
displayed, press ENTER.
The telescope is now asking
you to key-in the current me
in 24 hour format –
hours:minutes:seconds,
perhaps 19:33:12. Press
ENTER when all digits inserted.
If daylight saving does not
apply, press ENTER to select
standard me.
Queensland is in internaonal
me zone +10. Press ENTER of
“ZONE 10” is displayed, or use
the Up/Down keys to move to
10, then press ENTER.
Key in the current date in
American mm:dd:yy format.
Press ENTER.
2-Star Alignment
You are now ready to align the telescope with the stars in the sky. But to do this you needed to rst
set the correct me, date and me zone in the telescope. But that is now done.
Before you start the alignment process you will need to familiarise yourself with some of the brighter
stars in the sky as the telescope will soon ask you which two stars you want to align it to. At the rear
of this document are four star charts, two for early April and two for early August. One chart for