2 | ENGLISH
SOLAR WARNING
Never look directly at the Sun with the naked eye or with a telescope unless you have the proper solar fi lter. Permanent and irreversible eye damage may result.
Never use your telescope to project an image of the Sun onto any surface. Internal heat build-up can damage the telescope and any accessories attached to it.
Never use an eyepiece solar fi lter or a Herschel wedge. Internal heat build-up inside the telescope can cause these devices to crack or break, allowing unfi ltered sunlight to
pass through to the eye.
Do not leave the telescope unsupervised, especially when children or adults unfamiliar with the correct operating procedures of your telescope are present.
We recommend saving your telescope box so it can be used to store the telescope when it is not in use. Unpack the
box carefully as some parts are small. Use the parts list below to verify that all parts and accessories are present.
PARTS LIST
THE MOUNT & TELESCOPE TUBE
Your FirstScope’s mount and telescope tube are fully assembled. Simply remove the telescope and mount from the box
and set it on a stable surface, such as a table or picnic bench. Be sure to use a support that allows you easy access to
the eyepiece as you move the telescope around the sky.
Your FirstScope’s altazimuth mount was designed to rotate smoothly up, down, left or right with just a gentle push from
your fi ngers, making it easy to track celestial objects as they appear to drift across the night sky.
ASSEMBLING YOUR TELESCOPE
WHAT’S IN THE BOX
20 mm Kellner eyepiece (1.25”)
Dust cover, large
Dust cover, small
10 mm Kellner eyepiece (1.25”)
Fig. 1
Telescope tube and mount (preassembled)
To Next Page
Loading...
