2 | ENGLISH
Unpack your telescope and verify that all parts are
present. Your NexStar 102SLT MAK includes: a
telescope tube, a tripod, a motorized fork arm mount,
an accessory tray, two eyepieces, a 90° star diagonal,
a finderscope, a NexStar hand control and hand
control holder.
To set up the tripod, spread the legs outward until
they are fully extended and push down center leg
brace.
ITEM #23090
Extend the legs of the tripod by loosening the three
hand knobs on each leg. Pull each leg section all the
way out and tighten the hand knobs down to secure
them in place. Use the bubble level on the tripod head
to ensure the tripod is level.
ENGLISH
Quick Setup Guide
Place the hole in the accessory tray over the bayonet
mount on the tripod’s center leg brace. Rotate the
accessory tray until the three locking tabs insert into the
locking clips on each section of the central leg brace.
Snap the hand control holster, with the square tab
facing upward, around any one of the tripod legs.
Place the motorized fork arm over the top of the
tripod head and tighten the large captive knob
between the tripod legs to lock the mount in place.
Attach the telescope optical tube by positioning
the dovetail into the dovetail holder on the fork arm.
Make sure the bottom of the dovetail is flat against
the dovetail holder. Firmly tighten the hand bolt to
secure the clamp.
7
2
4
6
3
5
1
To Next Page
