Charging the batteries the rst time
1. After inserting the batteries, connect the Core
with the supplied power adapter. The Core
can be docked in the Main Stand or plugged in
directly.
2. Allow the batteries to charge until full .
You may run the G200 on any setting while
charging.
3. Turn the unit on to Speed 1 and remove the
power adapter plug.
4. Allow the unit to fully discharge and power off.
This operation can take up to 30 hours.
5. Fully charge the unit again per Steps 1 and 2
above. The batteries are now properly charged
for maximum performance.
Properly charging the batteries will allow maximum
runtime and battery life. The following procedure
should be followed on the rst charge of any new
batteries.
This procedure can be repeated if the battery life
is lower than expected. If this procedure fails to
increase battery life, contact Customer Care at
1-833-CELIOS1 or customer.care@celios.com.
To Next Page
Loading...
