CellarPro 3200VSi-ECX - Page 12




12V3.15.22
 Mounttheunitintheuprightpositionclosetotheceilinginsidethecellar.Aswarmairrises
tothetopofthecellar,thecoolingunitpullsthewarmairthrough the evaporator coiland
removestheheatfromthewarmair.Oncecooled,thecoldairisdischargedfromthefrontof
thecoolingunitandcirculatesthroughthecellar.
 Slidetheunitthroughfromtheoutsideofthecellar.CAUTION:Twopeoplearerequiredto
movethecoolingunit,whichisveryheavy.Donotplacethecoolingunitonunprotectedbottle
racks.
 Mountlevel,ortiltthecoolingunitslightlybackwards.Therearofthecoolingunitshouldbe
levelorslightlylower(1/8”max.)thanthefrontofthecoolingunittofacilitatethe flowof
excesscondensatetothedrainline.
 Useouradjustablemountingbracketstosupportandanchorthecoolingunittotheframing
inthewall.Usethe(16)#10x1‐1/2” flatPhillipsheadwoodscrewsprovidedtoanchorthe
screwsintothestudsandbraces.Themountingbracketscanbeusedeitherinsideoroutside
thecellarandcanbeusedinthreedifferentlocations,asshownbelow.

