Cellini CAP12V - Product Maintenance; Filter Care and Replacement Guidance; Troubleshooting Guide; Common Issues and Solutions

7
The lifetime of the filter differs based on indoor environment, usage times and usage
location.
Product maintenance
White primary filter layer can often be torn off the magic paste for washing (or wiping),
and then expose it under the sun; for drying, paste back the filter to original position .
It is suggested to clean the primary filter in every half month to clear away the large
pollutant, like hairs . as the above way. Also is suggested to change HEPA filter set after
1500 hours operation or using 6 months in total . Please contant Our after sales center for
filter purchase .
Waring: do not flush by water or soak the HEPA and Nano Photocatalyst filter to be
used on this product.
Common failure
Possible cause
Troubleshooting
The unit is not
working
The power cord is not plugged or
power has no electricity
Plug in the power supply;
ensure the power supply is
working.
Power switch is not on.
Press “on/off” button.
The purification
effect is poor
End of service life.
Change a filter.
Air inlet/outlet is blocked
Clean foreign parts of air
inlet/outlet
Wrong installation of front and
back side of filter
Install filter in the right way
The air volume
is weak
The filter is too dirty
Change a filter
Please make sure all the package is
removed.
Abnormal noise
exists
Please make sure all the package is
removed and check any damage on
the appearance.