BIO X6 User Manual v. 1.0 53
8. Layer group: This whole box specifies the layer parameters for printing a specific set
of layers.
9. Edit layer group: Tap to select layers for a layer group or to erase a layer group.
10. Create new layer group: Tap to create a new layer group.
11. Generate support structure: Tap to automatically generate a support structure for
your construct. You will need to designate a printhead for printing this structure
support.
12. Preview slider: Drag this to select which layer to preview. The total number of layers
may vary depending on the selected layer height (1).
To Next Page
