FITTING YOUR TIE DOWN ELECTRIC BLANKET
Place the Electric Blanket onto the mattress with the controller/s at the HEAD END but
towards the foot end of the bed.
The control switches should be below the Electric Blanket at the head end.
Unroll the tie tapes and pass the tapes under the bed as shown in the diagrams below.
Ensure the heating wires do not extend under pillows or hang over the sides.
Also ensure the controller cable is clear of where you may sit on the edge of the bed so
that it doesn’t get damaged.
Blanket should now be firmly tied with knots to the mattress.
SUPPORT AND TECHNICAL ADVICE
Celsius – New Zealand
Monday – Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
info@celsius.co.nz
Celsius – Australia
Monday – Friday 8am-5pm
Phone +61 (0)3 9365 5100
Phone 1300 465 324
info@celsiusforhome.com.au
TECHNICAL SPECIFICATION
Model No: CELQEB-LS CELQEB-Q CELQEB-K
Supply: 220-240VAC 50Hz 220-240VAC 50Hz 220-240VAC 50Hz
Wattage: 60W 2 x 60W 2 x 65W
Important Instructions
Retain for future use
To Next Page
Loading...