Need help?Do you have a question about the CEM DT-5302 and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Resistance Range | 200Ω/2kΩ/20kΩ/200kΩ/2MΩ/20MΩ |
| Temperature Measurement | -20°C to 1000°C |
| Data Hold Function | Yes |
| Backlight | Yes |
| Diode Test | Yes |
| Continuity Buzzer | Yes |
| Continuity Test | Yes |
| Display Count | 2000 |
| Operating Temperature | 0°C to 40°C |
| Power Supply | 9V Battery |
| Display | 3.5 digit LCD |
| DC Voltage Range | 200mV/2V/20V/200V/600V |
| DC Current Range | 200μA/2mA/20mA/200mA/10A |
| AC Current Range | 200mA/10A |
| Capacitance Range | 2nF/20nF/200nF/2μF/20μF |
| Frequency Range | 2kHz/20kHz |
Critical warnings for safe operation, including voltage limits, proper handling, and capacitor discharge.
Explains how ohmmeters measure resistance, including the effect of wire resistance.
Outlines display, range, current, sampling rate, and indicators for the tester.
Details accuracy, resolution, and current for low resistance ranges.
Lists accuracy and resolution for Ohms, DC Current, and AC Current measurements.
Provides accuracy and resolution for DC/AC Voltage and Capacitance measurements.
Identifies and labels the digital display, buttons, rotary switch, and input jacks.
Explains how to freeze the current measurement for later reference.
Details capturing the highest or lowest measurement.
Describes turning on the backlight and selecting measurement modes.
Guides on connecting leads and setting the meter for voltage and current readings.
Instructions for performing resistance measurements and continuity tests.
Procedures for testing diodes and measuring capacitance values.
Specific steps for measuring low resistance values accurately.
Step-by-step guide on replacing the meter's batteries when the low battery indicator appears.
To Next Page
