To Next Page

To Previous Page

I. SAFETY INFORMATION

1. NEVER apply voltage or current to the meter that exceeds the

specified maximum:

2. USE EXTREME CAUTION when working with high voltages.

3. DO NOT measure voltage if the voltage on the "COM" input

jack exceeds 1000V above earth ground.

4. NEVER connect the meter leads across a voltage source while

the function switch is in the current, resistance, or diode mode.

Doing so can damage the meter.

5. ALWAYS discharge filter capacitors in power supplies and

disconnect the power when making resistance or diode tests.

6. ALWAYS turn off the power and disconnect the test leads

before opening the covers to replace the fuse or batteries.

7. NEVER operate the meter unless the back cover and the

battery and fuse covers are in place and fastened securely.

8. If the equipment is used in a manner not specified by the

manufacturer, the protection provided by the equipment may

be impaired.

Questions and Answers:

Need help?

Do you have a question about the CEM DT-5302 and is the answer not in the manual?

CEM DT-5302 Specifications

General