CEM DT-8861 User Manual

① Hold the meter by its Handle Grip and point it
② P
Replace the battery if the display does not
ress the DOWN button to
e trigger is
released.(Unless the unit is locked on)
Not
toward the surface to be measured.
ull and hold the Trigger to turn the meter on and
begin testing. The display will light if the battery is
good.
light.
③ Release the Trigger and the HOLD display icon
will appear on the LCD indicating that the reading is
being held. In HOLD status, press the UP button to
turn on or off the laser. And p
turn on or off the backlight.
④ The meter will automatically power down after
approximately 7 seconds after th
e: Measurement considerations
Holding the meter by its handle, point the IR Sensor
toward the object whose temperature is to be measured.
The meter automatically compensates for temperature
deviations from ambient temperature. Keep in mind that
it will take up to 30 minutes to adjust to wide ambient
temperatures are to be measured followed by high
11

CEM DT-8861 Specifications

General

Brand	CEM
Model	DT-8861
Category	Thermometer
Language	English