Need help?Do you have a question about the CEM DT-8833 and is the answer not in the manual?
General| Brand | CEM |
|---|---|
| Model | DT-8833 |
| Category | Thermometer |
| Language | English |
Identifies the primary trigger for activating measurement and the device.
Displays recorded temperature values for Max, Min, Differential, Average, High/Low Alarms, and Type K.
Icons representing recorded data for Emissivity, Max, Min, Diff, Avg, High/Low Alarms, and Type K.
Displays the real-time temperature reading of the target.
Button to cycle through various measurement modes like MAX, MIN, AVG, etc.
Button to toggle the laser pointer and display backlight on or off.
Position the thermometer by its grip, aiming the sensor at the target.
Squeeze the trigger to power on and initiate the measurement.
Observe the SCAN icon on the LCD during active measurement.
Release trigger; HOLD icon appears, indicating the reading is stored.
LCD displays '---' when battery power is insufficient, requiring replacement.
Open cover, remove old battery, insert new 9V battery, and replace cover.
To Next Page
