To Next Page

To Previous Page

- -

ALARM right.

To set values for the High Alarm (HAL), Low Alarm (LAL)

and Emissivity (EMS), firstly active the display by pulling the

trigger or pressing the MODE button, then press the MODE

button until the appropriate code appears in the lower

left corner of the display, press the UP and down buttons to

adjust the desired values.

6. MEASURMENT OPERATION

① Hold the meter by its Handle Grip and point it

toward the surface to be measured.

② Pull and hold the Trigger to turn the meter on and

begin testing. The display will light if the battery is

good. Replace the battery if the display does not

light.

③ While measuring, the SCAN display icon will

appear in the upper left corner of the LCD.

④ Release the Trigger and the HOLD icon will

appear on the LCD indicating that the reading is

being held.

⑤ The meter will automatically power off after

approximately 7 seconds after the trigger is

released.(Unless the unit is locked on)

Questions and Answers:

Need help?

Do you have a question about the CEM DT-8833 and is the answer not in the manual?

CEM DT-8833 Specifications

General