switches itself on automatically when the test starts,
and switches itself back off when the test has been
completed. Check for correct functioning before
beginning the test. If you connect the two test tips
with each other, you should heap a beep, and the
continuity LED should light up. If this is not the case,
replace the batteries as described under
„Inserting/Changing the Batteries“. The continuity
tester indicates resistances of up to<300 kOhm.
Using the Voltage tester as a ”
single-pole” phase tester
The Voltage tester can also be used as a
„single-pole“ phase tester. Always hold the voltage
tester by the handles designed for this purpose (3
and 6). Never touch the device beyond the handle
ends.
This “phase test” serves as a quick test only.
Please check again for zero potential with the
twin-pole measuring method before you do any
To Next Page
Loading...
Need help?
General