To Next PageTo Next Page
Need help?Do you have a question about the CEMONT Blumig 303S and is the answer not in the manual?
MIG/MAG welding professional generators, three-phase feeding, forced ventilation, prepared for separated wire pulling set.
DATA PLATE sections for different models showing voltage, frequency, consuption etc.
Lists included accessories like earth cable and digital instruments.
Explains the percentage of time a welder can operate without overheating.
Shows the welder's maximum output currents and voltage.
Instructions for unpacking and assembling the machine and accessories.
Guidance on safely connecting the welder to the mains power supply.
Procedures for safe lifting, moving, and transporting the welding equipment.
Guidelines for choosing a suitable and safe place to operate the welder.
Steps for safely installing and securing the gas cylinder.
Instructions for setting up the wire spool and feeding the wire.
Steps to follow for powering on and preparing the welder for operation.
Identifies and explains the function of controls located on the front panel.
General steps for connecting and preparing for welding operations.
Specific guidelines for welding carbon steel materials.
Specific guidelines for welding stainless steel materials.
Specific guidelines for welding aluminum materials.
Procedure for performing spot welding operations.
Procedures for maintaining the welding torch, including nozzle and wire guide.
Steps for properly connecting the welding torch to the machine.
General| Input Power | 5.5 kVA |
|---|---|
| Input Frequency | 50/60 Hz |
| Efficiency | 85% |
| Insulation Class | H |
| Electrode Diameter | 1.6-5.0 mm |
| Duty Cycle | 60% |
