Page 4 For technical questions, please call 1-888-866-5797. Item 59410
SAFETY OPERATION MAINTENANCESETUP
15. People with pacemakers should
consult their physician(s) before
use. Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference
or pacemaker failure.
16. Do not test voltage on circuits
higher than 600 volts. This type
of testing should only be done
by a qualified electrician.
17. Store idle equipment. When not
in use, Meter must be stored in a
dry location to decrease exposure
to moisture. Lock up Meter and
keep out of reach of children.
18. Dress properly. Protective,
electrically nonconductive
clothes and nonskid footwear are
recommended when working.
19. Wear ANSI-approved safety
goggles during use.
20. Only use accessories intended
for use with this Meter.
21. The warnings, cautions, and
instructions discussed in this instruction
manual cannot cover all possible
conditions and situations that may
occur. It must be understood by the
operator that common sense and
caution are factors which cannot
be built into this product, but must
be supplied by the operator.
22. Avoid damaging Meter. Use only
as specified in this manual.
23. Performance of this Meter may vary
depending on battery condition.
24. Use the proper settings, terminals,
techniques, and range for the
tests performed. Start with the
range stated in the instructions.
25. Do not apply voltage to the Test
Leads when the Meter is in the
Ohms testing setting. Damage
can occur to the Meter.
26. Do not switch between testing modes
with the Meter connected to a circuit.
27. Prior to testing capacitors, resistance,
diodes, or continuity; disconnect all
power to the circuit and discharge
all high-voltage capacitors.
28. Have the Meter calibrated by a
qualified technician every year.
A Meter that is not calibrated yearly
may not yield accurate results.
SAVE THESE INSTRUCTIONS.
To Next Page
Loading...
Need help?
General
