Need help?Do you have a question about the Centec 2B and is the answer not in the manual?
Attaching the milling machine to its pedestal base.
Steps for initial setup, including cleaning and lubrication.
How to install a milling cutter onto the horizontal spindle.
Explanation of table and knee movement controls.
Procedure for converting the machine to vertical milling.
Instructions for fitting and using the swivelling table accessory.
How to install and use the standard vertical milling attachment.
Guide for fitting and operating the sliding spindle attachment.
Procedure for altering the feed rate on the power feed unit.
Lubrication, greasing, and oil change intervals for the machine.
How to adjust slides and spindle bearings for wear.
Exploded view and part list for the main body assembly.
Diagram and part reference for the power feed unit.
List of available spare parts for the underslide assembly.
To Next Page
General