Need help?Do you have a question about the Centec 2A and is the answer not in the manual?
Instructions for securing the milling machine to its pedestal using base plate bolts.
Precautions regarding careful handling to maintain the accuracy of the precision machine tool.
Steps to remove the base plate and mount the machine onto the pedestal securely.
Procedures for initial setup, including cleaning, lubrication, and oil filling.
Guidance on connecting pedestal and bench machines to the mains supply.
Instructions for installing a milling cutter onto the horizontal spindle.
Explanation of operating the table via ball handle or hand lever.
Details on vertical knee movement and limiting slide movements with stops.
How to select spindle speeds for the 2A/2B and No. 2 Milling Machines.
Instructions for unlocking and fitting the optional swivelling table.
Procedure to change from horizontal to vertical milling setup.
Installation and operation of the Standard V.M.A.
Instructions for operating the Sliding Spindle Vertical Milling Attachment.
Steps to engage, operate, and disengage the power feed attachment.
Method for adjusting the feed rate using pick-off gears.
Recommendations for lubricating machine components with specific oils and greases.
Methods for adjusting machine slides and main spindle for wear.
To Next Page
General