Center 340017 User Manual

Installation Guide
R32345746-002
340017 (EHE0200373)
RF Wireless 7 Day Programmable Thermostat
IMPORTANT: Please read these instructions fully prior to use as
they contain information that will help get the best from your
wireless thermostat, ensuring it is operating correctly and safely.
If during the installation or set up you experience any issues
please call 0344 292 7060 for assistance.
Must be installed by a competent person. To ensure your
safety make sure the mains power is switched OFF before
accessing wiring.
To prevent a short circuit from a loose wire:
• Multi-core cables: Only remove enough outer insulation
to allow secure fixing of the cores into the terminal block.
• Single core cables: Secure them together with a cable tie
as close as possible to the terminal block.
The Thermostat and Receiver Box within this pack are
Pre-bound
Install the Receiver Box
1 2
3
4 5
Wiring
On/off boiler (230V) 2-Port Zone ValveCombi boiler
ON
>30cm
0-30cm
Receiver Box
Basic Boiler
5(3)A
Permanent Live
not required
Receiver Box
5(3)A
Combi-
Boiler
T2T1
Receiver Box
5(3)A
V4043
Zone Valve
= M3.5
= N°6
a.
1.5-2.5mm²
6mm max.
2
1
Contents
2 x AA LR6Accessories Table Stand Receiver BoxThermostat Wall Mount

Center 340017 Specifications

General

Brand	Center
Model	340017
Category	Thermostat
Language	English

Summary

Important Installation Guidance

Safety and Pre-installation Notes

Essential safety warnings, installation by competent persons, and preventing short circuits from wiring.

Pre-bound System Components

Information that the thermostat and receiver box are pre-bound for immediate use.

Receiver Box Installation

Receiver Box Placement Requirements

Specifies minimum distance requirements (0-30cm and >30cm) for installing the receiver box.

Receiver Box Wiring Configurations

Details wiring diagrams for On/off boiler (230V), Combi boiler, and 2-Port Zone Valve connections.

Thermostat Installation and Parameters

Thermostat Placement Guidelines

Visual guide showing recommended and discouraged placement locations for the thermostat.

Thermostat Parameter Configuration

Explanation of various programmable parameters for the thermostat, including Min. On Time and Fail Safe.

Mounting and Receiver Box Operation

Table Stand and Wall Mount Instructions

Step-by-step guides for assembling the table stand and mounting the thermostat on a wall.

Wireless Receiver Box Status Indicators

Details on LED indicators for good and lost wireless signal, and manual boiler override.

Binding and Rebinding Procedure

When Binding is Required

Conditions necessitating the binding operation, such as component replacement or incorrect data.

Step-by-Step Binding Process

Instructions for resetting, entering, and confirming the binding mode between thermostat and receiver.