Center 667888 User Manual

Twist & click
non-return valve
with retainer clip
Boiler Condensate Pump - Installation Guide
This pump is designed to collect condensate water from
large domestic and commercial gas & oil fired condensing
boilers and discharge it up to recommended maximum
5 metres head. The internal safety float is a low current
switch to stop the boiler system in the event of pump
failure. The pump is operated from an internal float switch.
ELECTRICAL WARNING!
Isolate before working on this unit.
Service Guide:
Flush the pump through with anti-bacterial wash every six
months to avoid sludge build-up in the pump housing.
NB The contractors should satisfy themselves that any
chemicals used are compatible with the working of the pump.
IMPORTANT:
Pump should be filled with water until motor runs, check for
leaks and proper discharge of water.
1
IN THE BOX
Information correct at the time of going to press.
10mm I.D. x 6m
Pipe Adaptor
Boiler installation
5m
Ensure that there are no kinks or trapped parts in the piping,
which must have an inside diameter of 6mm. Fix the pipe with
cable ties to the pump outlet.
IMPORTANT:
The pre-wired safety switch MUST ALWAYS be utilised.
667888

Center 667888 Specifications

General

Brand	Center
Model	667888
Category	Water Pump
Language	English

Summary

Product Overview and Initial Precautions

Electrical Safety Warning

Mandates isolation of the unit before any work is performed on it.

Pump Service and Maintenance

Important Usage and Safety Guidelines

Condensate Water Compatibility

Pump is designed for pH +2.2 condensate water only; avoid oily or dusty environments.

Hose and Wiring Installation

Cleaning Chemicals

Use only approved cleaning chemicals; unapproved ones can cause permanent damage.

Fault Condition Diagnosis

Power Supply Check

High Level Safety Switch Operation

Check if the hi-level safety switch has activated; assess pump performance against flow rate.

Outlet Pipe Blockage

Installation Procedure

Installer Qualification

Appliance must be fitted and serviced by a competent and qualified installer only.

Wiring Regulations

3A Hi-Level Safety Switch

A 3 Amp Hi-level safety switch is mandatory and must be fitted.

Installation Checklist