To Next PageTo Next PageWhat to do if the Central Boiler CLASSIC EDGE 350 Furnace door is open?
If the display indicates 'DO', ensure the firebox door is closed and properly latched. Inspect the firebox door seal; if it's not sealing correctly, replace it.
What to do if the Central Boiler CLASSIC EDGE 350 door seal is faulty?
If smoke comes from between the firebox door and the door frame for more than a short period after reloading, remove any deposits from the door frame's face and surface area. Inspect the firebox door seal and replace it if necessary.
Why is my Central Boiler Furnace water temperature too low?
If the system's heat load is too large, the water may not reach high enough temperatures, potentially leading to firebox corrosion. Re-evaluate the system to ensure the heat load matches the outdoor furnace capacity.
What to do if air is entering through the Central Boiler CLASSIC EDGE 350 firebox door?
Ensure the firebox door is properly latched and check the condition of the firebox door seal. Replace the seal if it is not sealing properly. If the firebox door doesn't close tightly, adjust it.
Why is my Central Boiler CLASSIC EDGE 350 Furnace water will not circulate?
If the system has been drained and refilled, or opened for any reason, it must be purged.
What to do if my Central Boiler CLASSIC EDGE 350 combustion air fan is obstructed?
Check the screen over the fan inlet and the inside of the fan for any obstructions.
Why does my Central Boiler CLASSIC EDGE 350 consume so much wood when heating a high volume of water?
High wood consumption is required for high volume water heating, such as for a car wash or swimming pool.
What to do if the Central Boiler CLASSIC EDGE 350 Furnace water level is low?
Check the water level at the sight gauge and add water, if necessary.
What to do if the Central Boiler CLASSIC EDGE 350 Furnace solenoid is stuck?
Remove any obstructions. Lubricate with WD-40 or a similar lubricant.
General| Model | CLASSIC EDGE 350 |
|---|---|
| Fuel Type | Wood |
| Weight | 1, 800 lbs |
| Heat Exchanger | Stainless steel |
| Firebox Volume | 3.5 ft³ |
| Firebox Dimensions | 30" W x 36" H x 36" D |
| Dimensions | 72 x 72 x 72 inches |
| Heating Capacity | 350, 000 BTU/hr |
