Central Hydraulics 32879 - Page 4

Page 4
For technical questions, please call 1-800-444-3353.
SKU 32879
Do not move workpiece while 3.
compressed.
Release load before service or 4.
maintenance.
Bolt to oor before use.5.
Keep area under arbor plates clear. 6.
If arbor plates rest on obstruction
(i.e., bolt, debris, etc.), it creates an
uneven press, causing excess stress
and possible breakage.
Do not stand directly in front of the 7.
press when loaded. Do not leave the
press unattended when loaded.
Avoid off-center loads. Do not 8.
operate if workpiece tilts or binds
during compression.
STOP and release compression 9.
if you suspect imminent structural
failure. If safe, inspect thoroughly and
reposition before proceeding.
Do not compress springs or other 10.
elastic objects. They could disengage
hazardously.
Keep bystanders out of work area.11.
20 Ton Limit. Do not operate the 12.
hydraulic jack beyond rated capacity.
Inspect before every use; do not use 13.
if parts are loose or damaged.
Jack service must be performed 14.
only by qualied repair personnel.
Service or maintenance performed by
unqualied personnel could result in
a risk of injury.
When servicing a jack, use only 15.
identical replacement parts - refer to
attached, product-specic parts list
and diagram. Follow instructions in
the “Inspection, Maintenance, And
Cleaning” section of this manual.
Use of unauthorized parts or failure to
follow maintenance instructions may
create a risk of injury.
Only use with accessories rated to 16.
handle the forces exerted by this tool
during operation. Other accessories
not designed for the forces generated
may break and forcefully launch
pieces.
Use only with bottle jack included 17.
with this press.
Industrial applications must follow 18.
OSHA requirements.
This product is not a toy. Keep it out 19.
of reach of children.
The warnings, precautions, 20.
and instructions discussed in
this instruction manual cannot
cover all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into this
product, but must be supplied by the
operator.
SAVE THESE
INSTRUCTIONS.