Central Hydraulics 32879 - User Maintenance Instructions

Page 9
For technical questions, please call 1-800-444-3353.
SKU 32879
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM TOOL FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Before each use, 1. inspect the
general condition of the Shop Press
and Bottle Jack. Check for broken,
cracked, or bent parts, loose or
missing parts, and any condition that
may affect the proper operation of the
product. If a problem occurs, have
the problem corrected before further
use.
Do not use damaged equipment.
Before each use, thoroughly test 2.
the Bottle Jack (14) for proper
operation prior to its actual use. If
the Bottle Jack appears not to be
working properly, follow Bleeding
the Bottle Jack instructions.
Change the hydraulic oil at least 3.
once every three years. To change
the hydraulic oil:
With the Jack fully lowered, unhook a.
the Springs from the Eye Bolts and
remove the Jack from the Shop
Press.
Remove the Oil Filler Plug.b.
Tip the Bottle Jack to allow the old c.
hydraulic oil to drain out of the unit
completely, and dispose of the old
hydraulic oil in accordance with local
regulations.
Completely ll the unit with a high d.
quality hydraulic oil (not included)
until the oil just begins to run out of
the Oil Fill Hole.
Reinstall the Oil Filler Plug.e.
Clean with a clean cloth using a f.
detergent or mild solvent.
Replace the Bottle Jack onto the g.
Shop Press (See step 7 under
Assembly).