Page 3 Floor Jacks
Lift vehicle only at manufacturer-rec-12.
ommended locations.
Inspect before every use; do not use 13.
if parts loose or damaged.
Keep your work area clean and well 14.
lit. Cluttered work areas invite acci-
dents.
Keep bystanders, children, and 15.
visitors away while operating jack.
Distractions can cause you to lose
control.
Stay alert. Watch what you are do-16.
ing, and use common sense when
operating a jack. Do not use a jack
while tired or under the inuence of
drugs, alcohol, or medication. A mo-
ment of inattention while operating
jacks may result in serious personal
injury.
Store idle jacks out of reach of chil-17.
dren and other untrained persons.
Jacks are dangerous in the hands of
untrained users.
Jack service must be performed only 18.
by qualied repair personnel. Service
or maintenance performed by unqual-
ied personnel could result in a risk of
injury.
When servicing a jack, use only iden-19.
tical replacement parts - refer to at-
tached, product-specic parts list and
diagram. Follow instructions in the
“Inspection, Maintenance, And Clean-
ing” section of this manual. Use of
unauthorized parts or failure to follow
maintenance instructions may create
a risk of injury and may void any ap-
plicable warranty.
Maintain labels and nameplates on 20.
the Jack. These carry important
information. If unreadable or miss-
ing, contact Harbor Freight Tools for a
replacement.
Before use, read manufacturer’s 21.
instruction manual for the vehicle (or
object) you will lift.
When lifting only one wheel, support 22.
the load immediately with one jack
stand (not included) placed under the
side of the vehicle being lifted. Align
the saddle of the jack stand directly
under the vehicle’s seam or recom-
mended lifting point.
When lifting the entire front end 23.
or rear end of a vehicle, support
the load immediately with two jack
stands. Align the saddles of the jack
stands directly under the vehicle’s
frame or recommended lifting points.
Also, adjust the jack stands to the
same height.
Do not work under the vehicle without 24.
properly supporting the vehicle with
jack stands.
Avoid dangerous oncoming trafc. 25.
Use the Jack as far away from the
roadside as possible.
Industrial applications must follow 26.
OSHA requirements.
Do not allow anyone in the vehicle 27.
while using the Jack. Keep all by-
standers a safe distance away from
the vehicle.
Do not support both ends of the ve-28.
hicle at the same time.
Before lowering the Jack, remove all 29.
tools and equipment from under the
vehicle.
To Next Page
Loading...
