Central Machinery 40668 - Specifications; Features of this Buffer

SPECIFICATIONS MODEL # 40668 BUFFER
Motor: 115V, 8.2 Amps, 60 HZ,
Single Phase, 3/4 HP, 3450 RPM
Extended Shaft Diameter: 3/4”
Spindle Thread: 3/4” x 12 TPI
Spindle Length: 2-5/16”
Mounting Flange: 3-3/8” diameter
Base Size: 8” x 5-3/4”
FEATURES OF THIS BUFFER
1. Double-endedspindleaccommodatesbothPolishingandBufngwheels.
2. Powerful3/4HPmotordeliverseffectivepolishingandbufngat3450rpm.
3. HeavyCastIronconstructionprovidesasturdybaseforpolishingworkpieces.
4. Rubberfeetreducevibration.
5. Ballbearingconstructionprovidessmooth,reliableperformance.
6. Pull-onPush-offsafetyswitchiseasytousewhilehandlingworkpieces.
7. Nomaintenancerequired,otherthanperiodicreplacementofwheels.
SAVE THIS MANUAL
Youwillneedthismanualforthesafetywarningsandcautions,assemblyinstructions,operating
procedures,maintenanceprocedures,troubleshooting,partslist,anddiagram.Keepyourinvoice
withthismanual.Writetheinvoicenumberontheinsideofthefrontcover.Keepboththismanual
andyourinvoiceinasafe,dryplaceforfuturereference.
Page 2 SKU # 40668
NOTICE
The Warnings, Cautions, and Instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
Rev03/02